The sensors enable you to read: Orientation (yaw, pitch & roll) via an accelerometer, 3D gyroscope, and magnet ometer Pressure HumidityTemperature To Install: Connect your Sense HAT to the Raspberry Pi via the 40 GPIO Pins Open up a terminal and run the following command: (This will take approximately 5 minutes to run on the Raspberry Pi 2 Model B, and approximately 20 minutes on earlier models of the Raspberry Pi)When the install is finished you will need to reboot your Raspberry Pi Note: The Raspberry Pi Sense HAT is compatible with the Raspberry Pi 3, Raspberry Pi 2 , and Raspberry Pi A+, but NOT the earlier 26-pin models of Raspberry Pi 1 Model B & A's. Pi not included!
General
Brand
Raspberry PI
Model
-
Quantity
1Set
Form Color
Black + Green
Material
ABS, PCB
Specification
English Manual / Spec
No
Dimensions & Weight
Dimensions
3.66 in x 2.48 in x 1.02 in (9.3 cm x 6.3 cm x 2.6 cm)
This website uses cookies for the correct display and functionality. Do you also want to take full advantage of the website and accept cookies? About cookies. Accept cookies
