This product is to connect the new SATA hard disk to the old IDE motherboard. The old IDE hard disk is connected to the new SATA board. Please note the difference!
Warm prompt: this section transfers the card to be able to meet 137G following hard disk, cannot connect the CD driver.
Installation instructions:
1., before the operation of the computer host power should be closed;
2. open the computer case, insert the SATA seat of the adapter board into the SATA device (the hard disk of the SATA interface, etc.), and set the master and slave jumper of the SATA device to the main equipment (Master);
3. connect the large end of the power line to the power line of the chassis power supply, and the small end is attached to the adapter board;
4., one end of the data line is connected to the IDE seat of the computer mainboard, and the other short connection product is connected with SATA!
5. after the connection, the computer boot into the BIOS for device testing, the computer host should be able to correctly identify the connected SATA device.
Connection method:
1. insert the IDE port of the conversion card to the main board IDE interface;
2. SATA data line (distribution) is inserted into the conversion card at one end, and the other end is connected to the SATA hard disk;
The 3. conversion card is connected with the power line (distribution), and the other end of the power supply wire is connected with the power cord of the case;
4., SATA hard disk power conversion line, and then the chassis power, so that the connection is good, you can start the computer power.This product is to connect the new SATA hard disk to the old IDE motherboard. The old IDE hard disk is connected to the new SATA board. Please note the difference!
Warm prompt: this section transfers the card to be able to meet 137G following hard disk, cannot connect the CD driver.
Installation instructions:
1., before the operation of the computer host power should be closed;
2. open the computer case, insert the SATA seat of the adapter board into the SATA device (the hard disk of the SATA interface, etc.), and set the master and slave jumper of the SATA device to the main equipment (Master);
3. connect the large end of the power line to the power line of the chassis power supply, and the small end is attached to the adapter board;
4., one end of the data line is connected to the IDE seat of the computer mainboard, and the other short connection product is connected with SATA!
5. after the connection, the computer boot into the BIOS for device testing, the computer host should be able to correctly identify the connected SATA device.
Connection method:
1. insert the IDE port of the conversion card to the main board IDE interface;
2. SATA data line (distribution) is inserted into the conversion card at one end, and the other end is connected to the SATA hard disk;
The 3. conversion card is connected with the power line (distribution), and the other end of the power supply wire is connected with the power cord of the case;
4., SATA hard disk power conversion line, and then the chassis power, so that the connection is good, you can start the computer powe