Installation:
Open the engine hood and find the sticker below it. If the sticker has words like OBDII CERTIFIED, then this HUD can be installed (Most models newer than 2006 have been equipped with OBD).
Find out the 16-pin diagnostic link of the vehicle and connect it well with OBD connecting cable.
Put the anti-slip mat on any flat surface and fix the HUD onto it. HUD can be adjusted according to demand.
Stick the reflective film right above the HUD and make sure it can reflect the whole display screen.
Methods of pasting the film:
Spray some water on the place that the film will be pasted on.
Tear off the protection cover of film and spray some water to both sides, then stick it to the right place.
After you have adjusted the location well, you can use a scratch board or something else flat to stick the film and squeeze the water inside out until there is no bubble or water in it.
Parameters:
Environment temperature: -40~+80'C
Barometric pressure: 86~106KPa
Relative humidity: 10~95%
Environment noise: <= 60dB (A)
Sound level of alarm: >= 30dB (A)
Working voltage: 9~16V DC (12V DC / 400mA)