The remote control and receiver module already contain 2262/2272 codec chip, decoding MCU. The remote control is fixed code output so that all the same type remote controls can be used interchangeably.
Before using the kit, the spring antenna should be soldered to the ANT pad of the receiver module. And then power on and you should pair the the remote control and receiver module. Paring method:
Press and hold the on-board learning button for two seconds, the learning indicator led will flash once so that it enters the learning mode. Release the button and press any key of the remote control. The indicator flashing 4 times tells paring success and then it exits learning mode.
Output mode:
- Default (T2, T1 float) is the direct mode, when you press the remote control button, the receiver module corresponding pin outputs high until the button is released. And then it will output low.
- Back side of the board (T2 ground, T1 float) is self-locking mode, press the remote control button, signal status of the receiver module corresponding pin flips, so if the original output is low, then it changes to high level, and vice versa.
- Back side of the board (T2 float, T1 ground) is interlocked mode, press the remote control button, the receiver module corresponding pin outputs high, other pins output low, and will maintain this output status until other key is pressed.
Receiver Module:
- Operating voltage: 3.3-5.5VDC
- Operating Current: 5mA(MAX)
- Operating frequency: 433MHz
- Output pins: 4 (D0, D1, D2, D3) corresponding to the remote control buttons A / B / C / D
- Support remote control: remote control with 2260, 2262, 2240, 1527 and other chips
- Antenna: ANT antenna pads can be welded spring antenna
- Great for DIY
Remote control:
- Operating voltage: 12V
- Battery type: 23A, 12V
- Operating Current: 10mA (max)
- Operating frequency: 433MHz
- Number of buttons: 4