This is WiFi serial transceiver module, based on ESP8266 SoC which has integrated TCP/IP protocol stack.
It optimizes the filter circuit and reduces power consumption.It is an upgraded and improved version of ESP-07 module.
It is TTL serial communication interface and its parameters can be set by AT command. It is widely used in networking, smart home project when it is connected to the wifi router. It can be used for remote monitoring of home appliances, bedroom temperature and humidity, and controlling home appliances by the mobile phone.
Solder it to the ESP-07 adapter board and then it can be plugged directly into a breadboard or PCB experiment board.
Features:
- Compatible with pin pitch and pinout of ESP-07
- Working frequency: 2400 - 2484 MHz
- Working voltage: 3.0 - 3.6VDC
- Working current: 200mA(MAX)
- Serial port baud rate: 115200 (default), can be modified to other values ​by AT command
- Serial communication format: 8N1
- On-board flash capacity: 4M bytes
- Antenna Type: Built-in PCB antenna is available.
- Wireless Network Mode: station / softAP / SoftAP + station
- Wireless criteria: 802.11 b / g / n
- WIFI @ 2.4 GHz, support for WPA / WPA2 security mode
- It is very easy to design projects by AT command
- Note: When connecting with Arduino, you need to add 5V / 3.3V level converter circuit
- Applications: Home automation, sensor networks, industrial wireless control, smart car.

About the Adapter Board: It is used to convert the IO ports of ESP-07S to 2.54mm pitch pin headers, so it is easy for the beginner to test ESP-07S and learn wifi controlling.
Before using it, the user should first follow these steps:
- Firstly, Solder the ESP-07S to the adapter board;
- Secondly, Solder the 3.3V regulator to the bottom of the adapter board;
- Thirdly, Solder the 1X8P pin header to the adapter board;
- Because there is a 3.3v regulator onboard, the range of VCC pin on the adapter board can be 3.3V to 5V.
- Note: When you want to use the adapter board with the 3.3v regulator and apply 5v to the board, you also need to desolder the middle SMD resistor on the adapter board!